Four square file tool

File Type. Cut Pattern. Face Tooth Style. File Style. Abrasive Material. Number of Pieces. Finish Number. Container Type. Diamond Surface Length. View catalog pages 7. Send Cancel.

How can we improve? About Finishing. Square Files. File Sets. Square Files for Stainless Steel. Square Diamond Files. Needle Files. The best work is done when both hands are used to exert a consistent pressure, as well as control the file. Using one hand alone will result not only in an uneven cut, but there's a better chance that the file will deviate from the intended work area. When stock must be removed from a large workpiece, many craftsmen will make diagonal cuts to cover more area and produce a more even surface.

When a square file is used to clean out a right-angle interior cut, such as a woodworking mortise, it's sometimes not possible to provide pressure and guidance on the forward end of the file.

When this is the case, the work generally is done more slowly to avoid deviations in the cut and to ensure as consistent pressure as possible. A square file is only one of many that woodworkers and metalworkers will have in their toolboxes. Sign in Register. Cutting Wheel Set 4 pc. Woodcarving Tool Set 4 pc.

Modelling Tool Set 7 pc. Orders are Shipped from the USA. Woodworkers Carbide Tool Set. In case of a machine, the part is larger in size than the required size, a file is used to make it suitable. In addition, a file is used where other cutting tools cannot be used. Files are also used for sharpening the edge of some other cutting tools. A wooden handle is fitted on its tang.

Teeth are cut on its face and edge so that it can perform the job of cutting. The part having no teeth is called as heel. Thick side of file is called edge and its lower end is known as tip or point.

While making a selection of file for a specific job, some important points should be considered. In other words, we can say that files can be classified into the following categories:. A file is measured according to its length.

This length includes whole file except its tang portion i. In fitter trade, file of mm to mm length are used. This file is of rectangular cross-section in shape. It is made slightly tapered both in width and thickness. Double cut teeth are cut on the face and simple-cut teeth are cut on the edge.

These are used to reduce flat surface by filing of finishing. This type of file has a round section. It is used for rubbing or finishing keyhole of small diameter. It is a file which is on the side and curved on the other side. Double cut dents are cut on it and like a round file, it is also tapered. With this file, the damaged hole can be set in order again. It is triangular in shape.